Apollo

The DIN-Rail Zone Monitor with Isolator powers and controls a zone of up to 20 Apollo Series 65 or Orbis fire detectors in a Discovery or XP95 loop.

The Isolating Base senses and detects short-circuit faults on Discovery loops and spurs. Minimises dispruption from short circuits. Key Features ...

'The Sounder Control Unit is used to control the operation of a zone of conventional sounders and report their status to the control panel.'

The Apollo Multi-Tone Open-Area Sounder Visual Indicator is designed for use in indoor open areas and can be connected to any Discovery or XP95 sys...

The Apollo Series 65 break glass manual call point, consists of a 470 Ω resistor in series with a normally open switch contact. The manual call poi...

The Series 65 Auxiliary Relay base provides Two sets of volt-free changeover contacts to facilitate the Switching of a remote LED or other auxiliar...

The base provides one set of volt-free, changeover (form C) contacts that change state when the detector signals an alarm. Key Features Det...

The Soteria Dimension Mounting Box is moulded from white flame-retardant polycarbonate. Positions for either side or top cable entry are marked on ...

The XP95 Sounder VAD Base is a loop-powered sounder and EN 54-23 approved VAD combined with a standard intelligent mounting base. It is used to sig...

The XP95 Sounder VAD Base is a loop-powered sounder and EN 54-23 approved VAD combined with a standard intelligent mounting base. It is used to sig...

Leading brand Apollo. The XP95 Optical Smoke detector uses an internal pulsing infrared LED and a photo-diode at an obtuse angle. In clear air cond...

The XP95 Heat Detector (A2S) monitors temperature by using a single thermistor which provides a count output proportional to the external air tempe...

The XP95 Heat Detector (A2S) monitors temperature by using a single thermistor which provides a count output proportional to the external air tempe...

High heat detection, the XP95 heat detector monitors temperature by using a single thermistor which provides a count output proportional to the ext...

This product is subject to special to order - No Returns Are Accepted The XP95 IS Heat Detector is distinguishable from XP95 IS smoke detectors by ...

The Apollo XP95 manual call point is supplied with a short circuit isolator, resettable element and a surface mounting back box as standard. A sing...

The Sounder Visual Indicator Base is a loop-powered sounder and visual indicator combined with a standard Intelligent Mounting Base. It is used to ...

FA26 - APOLLO HEAT DETECTOR CLASS A1R WITH SOUNDER BEACON BASE W/ DUAL LEDS

Simple clip on, tough polycarbonate call point cover model FA56A. Ideal for protecting the call point and preventing accidental activation and hen...

A Series 65 optical smoke detector with flashing LED's. The Series 65 Optical Smoke Detector incorporates a pulsing LED located within the housing ...

A Series 65 optical smoke detector with flashing LED's. The Series 65 Optical Smoke Detector incorporates a pulsing LED located within the housing ...

The VAD has been developed as a primary or supplementary alarm device for use in situations where there is a risk that sounders will not be heard. ...

The Loop Powered VAD is designed for indoor use. The Category C VAD is specifically designed for use on a ceiling and comes in two different covera...