Manual Call Points (Break Glass)

A selection of manual fire alarms call points from leading manufacturers such as Fike Safety Technology, Apollo, C-TEC, Hochiki, STI, Cranford Controls, and many more.

Since 2017 it has been recommended as appropriate practice according to British Standards to fit a cover to all newly installed call points, and also where possible to retro-fit these.

It is important that you choose the appropriate call point for you fire alarm system and some are propriatory, such as the Twinflex. If in any doubt send up a picture of your existing fire alarm panel and a picture of the key hole, we will then match these for you if required.

Twinflex Manual Call Point. Manual Call point with Re-settable element reset key, back box, adaptor plate for flush mount and inbuilt ‘End of Line’ set by DIL switch.
Twinflex Manual Call Point. Manual Call point with Re-settable element reset key, back box, adaptor plate for flush mount and inbuilt ‘End of Line’...
£10.80
The Apollo Series 65 break glass manual call point, consists of a 470 Ω resistor in series with a normally open switch contact. The manual call point helps reduce installation time as all the initial installation cabling is wired to a terminal block which connects neatly to the call point. Once activated, the manual call point can be reset by in...
The Apollo Series 65 break glass manual call point, consists of a 470 Ω resistor in series with a normally open switch contact. The manual call poi...
£12.50

1 – 2 products of 2